Connecting Wires To Terminals - Kenwood KDC-MP632U - USB/AAC/WMA/MP3/CD Receiver With External Media Control Instruction Manual

Connecting Wires to Terminals (KDC-X590)
If no connections are made, do not let the wire come out from the tab.
Sub Woofer right output (Red)
Sub Woofer left output (White)
Power control wire (Blue/White)
Motor antenna control wire (Blue)
Dimmer control wire (Orange / White)
TEL mute wire (Brown)
~
• Do not remove the cap when you do not use the
~
USB cable. The connector will cause the unit to
malfunction if it gets in touch with any metallic part
of the vehicle.
• Fasten the connector with the tape so that the cable
will not come off.
FM/AM antenna input
~
To connect these leads, refer to
~ the relevant instruction manuals.
To Kenwood disc changer/ External optional accessory
[0
To USB device
Front left output (White)
Front right output (Red)
USB connector
To use the steering
wheel remote
&===m'
control feature,
you need to an
exclusive remote
adapter (not
supplied) matches
your car is required.
When using the optional power amplifier,
connect to its power control terminal.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for the
booster amplifier of the film-type antenna.
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
~
To connect the Kenwood navigation
~
system, consult your navigation manual.
To car light control switch
Steering remote
control (Light Blue/
Yellow)
8
White/Black
To front left speaker White
( f ) - - - - - - - - - - - '
8
Gray/Black
To front right speaker G
(f)_ra...;.,y ___
8
Green/Black
To rear left speaker Green
( f ) - - - - - - - - . . J
8
Purple/Black
To rear right speaker Purple
<±)
...J
Ignition key switch
~
@
Carfuse box
. - I_g_ni_ti_o_n_w_i_re_(_R_ed_) --'
I I
English
I 39
Battery wire (Yellow)
Ground wire (Black)
8
(To car chassis)
ACC
Car fuse box
~
(Main fuse)
Battery