Removing The Unit - Kenwood KDC-MP632U - USB/AAC/WMA/MP3/CD Receiver With External Media Control Instruction Manual

Removing the Unit
Removing the hard rubber frame
1
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Upper the frame and pull it forward as shown in
the figure.
Accessory@
Removal tool
2
When the upper level is removed, remove the
lower two locations.
~
~
• The frame can be removed from the bottom side in the
same manner.
44
I
English
Removing the Unit
1
Refer to the section <Removing the hard rubber
frame> (page 44) and then remove the hard
rubber frame.
2
Remove the screw (M4 x 8) on the back panel.
3
Insert the two removal tools deeply into the slots
on each side, as shown.
Screw (M4X8)
(commercially available)
\
~.
~.
4
Lower the removal tool toward the bottom, and
pullout the unit halfway while pressing towards
the inside.
&
• Be careful to avoid injury from the catch pins on the
removal tool.
5
Pull the unit all the way out with your hands,
being careful not to drop it.