Safety Precautions - Kenwood KDC-MP632U - USB/AAC/WMA/MP3/CD Receiver With External Media Control Instruction Manual

Safe,ty'precautions
AWARNING
To p.revent injury
or fire, take the
following precautions:
• To preventa short circuit, never put or leave any
metallic objects (such as coins or metal tools)
inside the unit.
• Mounting andwiri·rig this product requires
skills and experienc:e. For safety's sake, leave the'
mou ntingand .wi ri ng' work to professiona Is.
Attach thepanel·while.youare
on the .
vehicle
The panel lock arm appears when the panel is
removed. Therefore, the panel must be attached
while the electrical system of the car is operating.
ACAUTION
To prevent damage
to·
the machine, take
the following precautions:
• Make sure to ground the unit to a negative
12V
DC power supply.
• Do not install the unit in a spot exposed to direct
sunlight or excessive heat or humidity. Also avoid
places with too much dust or the possibility of
water splashing.
• Do not place the faceplate (and the faceplate
case) in areas exposed to direct sunlight, excessive
heat or humidity. Also avoid places with too much
dust or the possibility of water splashing.
• To prevent deterioration, do not touch the
terminals of the unit or faceplate with your
fingers.
• Do not subject the faceplate to excessive shock,
as· it is a piece of precision equipment.
• When replacing a fuse, only use a new fuse with
the prescribed rating. Using a fuse with the wrong
rating may cause your unit to malfunction.
• Do not apply excessive force to the open
faceplate or place objects on it. Doing so wi(1
cause damage or breakdown.
• Do not use your own screws. Use only the screws
provided. If you use the wrong screws, you could
damage the ulllit.
Do Not LO'ad 3-in.. CDs
i'n
the CD slot
If you try to load a 3 in. CD with its adapter into the
unit, the adapter might separate from the CD and
damage the unit.
About CD players/disc changer:s
connected to this
unit
Kenwood disc :changers! CD players released in
1998 or later can be connected to this unit.
Refer to the catalog or consult your Kenwood
dealer for connectable models of disc changers!
CD players.
Note that any Kenwood disc changers/COplayers
released in 1997 or earlier and disc changers made
by other makers cannot be connected tothis unit.
Connecting unsupported disc changers!CD players
to this unit may result in damage.
Set the "O-N" Switch to the "N" position for the
applicable Kenwood disc changers/ CD players.
The functions you can use and the information
that can be displayed may differ depending on the
models being connected.
~
• You can damage both your unit and the CD changer if
you connectthem incorrectly.
LX-bus connection
The LX AMP and the sensor unit must be connected
one at a time.
Lens Fogging
When you turnonthe car heater in cold weather,
dew or condensation may form onthe lens in the
CD player of the unit. Called lens fogging, this
condensation on the lens may not allow CDs to
play. In such a situation, remove the disc and wait
for the condensation to evaporate. If the unit still
does not operate normally after a while, consult
your Kenwood dealer.
The "AAC· logo is trademark of Dolby
Laboratories.
NOTE
This Class B digital apparatus complies with
Canadian ICES-003.