Audio Setup; Subwoofer Output - Kenwood KDC-X589 Instruction Manual

Audio Setup
Setting the Sound system, such as Cross over
Network.
5 Exit the Detail Audio Control mode
Press the [VOL] knob for at least 1 second.
~
~
• *2 You can control this item when
"2l0N"
of <Audio
Setup> (page 11) is set to "OFF".
• *3 KDC-X589/MP5028 only.
• *4 The Dual Zone System can be used with the
Auxiliary input sources shown below.
-Internal auxiliary input (KDC-MP5028/MP528 only)
- Option CA-C1AX (KDC-X589 only)
Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- The channel of sub source is set up by <Dual Zone
System Setting> (page 25).
- Main source is selected by [SRC] button.
- The volume of Front channel is adjusted by [VOL]
knob.
- The volume of Rear channel is adjusted by <Audio
Control> (page 10)
- The Audio Control has no effect on sub source.
• You can control this item when <Switching preout>
(page 25) is set to "SWPRE SW". (KDC-MP5028/MP528
only)
• You can control this item when "2Z0N" of <Audio
Setup> (page 11) is set to "OFF".
Subwoofer Output
5
Exit Audio Setup mode
Press [VOL] knob for at least 1 second.
Turning the Subwoofer output ON or OFF.
Hold down on [AM] of the Control knob for at
least 1 second.
Each time the button is pressed, Subwoofer
output switches ON and OFF.
When it's ON, "SW ON" is displayed.
~
Throughl 40*3/60*3/80/1001
120/ 150/1801220*3 Hz
Th roughI40*3160*3180/1 001
1201 150/1801220*3 Hz
Normal
(0
0
)1
Reverse
(180
0
)
-8-±O
50*3160/801700*3/1201
Through Hz
Volume offset "V-OFF"
Subwoofer Phase*1.2 "PHAS"
Low Pass Filter*1.2 "LPF"
Rear High Pass Filter*) "HPR"
Front High Pass Filter*z "HPF';
• When the Bass Extend is set to ON, low frequency
response is extended by 20%.
• You can exit the Audio Control mode at anytime by
pressing any button except for [VOL], [AD] and [ANG]
buttons.
1
Select the source for adjustment
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item for adjustment
Press the [VOL] knob.
Each time the knob is pressed, the items that can
be adjusted switch as shown below.
4
Setup the Audio item
Turn the [VOL] knob.
Loudness "LOUD" OFFION
Dual Zone System*4 "2Z0N" OFFION
~
~
• Volume offset: Each source's volume can be set as a
difference from the basic volume.
Loudness: Compensating for low and high tones
during low volume.
When it's ON, "LOUD" indicator is ON.
• *1You can control this item when <Switching preout>
(page 25) is set to "SWPRE SW". (Function of the KDC-
MP5028/MP528)
• *1 You can control this item when <Subwoofer
Output> (page
11)
is set to "SW ON".
English
I
11