Audio Adjust - Onkyo TX-NR5010 Instruction Manual

■
High Phase, Low Phase
0º
180º:
With this setting, you can adjust the phase of tweeters and
woofers.
Tip
• Sounds processed by Digital Processing Crossover Network are
played.
• You can switch from the current audio source to test noises by
pressing MODE/D (Blue).
■
High Distance, Low Distance
0inch(0.0cm) to 12inch(30.0cm) in 1 inch (2.5 cm)
steps.
With this setting, you can adjust the virtual position of
tweeter and woofer units. Adjusting "High Distance"
virtually shifts woofers behind tweeters. Adjusting "Low
Distance" virtually shifts tweeters behind woofers.
Tweeter
Distance
Woofer
(Low Distance) (High Distance)
Tip
• Sounds processed by Digital Processing Crossover Network are
played.
• You can switch from the current audio source to test noises by
pressing MODE/D (Blue).

Audio Adjust

1 2 3
Main Menu
With the Audio Adjust functions and settings, you can
adjust the sound and listening modes as you like.
Multiplex/Mono
■
Multiplex
Input Channel
Main
Sub
Main/Sub
This setting determines which channel of a stereo
multiplex source is output. Use it to select audio channels
or languages with multiplex sources, multilingual TV
broadcasts, and so on.
■
Mono
Distance
Input Channel
Left + Right
Left
Right
This setting specifies the channel to be used for playing
any 2-channel digital source such as Dolby Digital, or 2-
channel analog/PCM source in the Mono listening mode.
4 5
"Setup"
Audio Adjust
En-72
Advanced Operations
Output Speaker
Center:
Mono audio is output by the center speaker.
Left / Right:
Mono audio is output by the front left and right
speakers.
This setting determines which speakers output mono audio
when the Mono listening mode is selected.
Note
• If the "Center" setting is set to "None" (➔ page
cannot be selected.
Dolby
■
PL IIx Music (2ch Input)
These settings apply to only 2-channel stereo sources.
If you're not using any surround back speakers, these
settings apply to Dolby Pro Logic II, not Dolby Pro Logic
IIx.
Panorama
On
Off
With this setting, you can broaden the width of the front
stereo image when using the Dolby Pro Logic IIx Music
listening mode.
Dimension
–3 to 0 to +3
With this setting, you can move the sound field forward or
backward when using the Dolby Pro Logic IIx Music
listening mode. Higher settings move the sound field
backward. Lower settings move it forward.
If the stereo image feels too wide, or there's too much
surround sound, move the sound field forward to improve
the balance. Conversely, if the stereo image feels like it's
in mono, or there's not enough surround sound, move it
backward.
67), this setting