Power - TYAN TIGER I7322DP Manual

3.6 Power

These settings allow you to configure the power options for your system.
Main Advanced
Resume On Time:
Resume Time:
Power Button Behavior:
After Power Failure:
Cabinet Monitoring:
Power On By PCI/PCI-X
F1 Help Select Item
↑↓
Esc Exit Select Menu
← →
Resume On Time
When enabled, this allows the system to be woken up at a specified time. This time
is specified by the Resume Time parameter.
Options: Off / On
Power Button Behavior
This specifies the behavior of the system after the power button is pressed.
Options: On/Off, Wake/Sleep.
On/Off - This powers on / powers off the system after the power button is pressed.
Wake/Sleep - This wakes the system from/puts the system to sleep.
After Power Failure
Specifies the mode of operation after the system recovers from a power loss.
Options: Enabled, Disabled.
Enabled: This restores the system to the last state it was in before the power loss
occurred.
Disabled: This keeps the power switched off till the power button is pressed.
Chassis Intrusion Detect
Enable/Disable: when chassis open event is detected, BIOS will record the event.
Options: Enabled / Disabled
Power On by PCI/PCI-X card
An input signal from PME on the PCI card awakens the system from a soft off state.
Options: Enabled / Disabled
PhoenixBIOS Setup Utility
Security
Power
[Off]
[xx:xx:xx]
[On/Off]
[Last State]
[No]
[Disabled]
-/+ Change Values
Enter Select
Sub-Menu
59
http://www.tyan.com
Boot Exit
Item Specific Help
Enabled wakes the
system up at a specific
time.
F9 Setup Defaults
F10 Previous Values