TYAN TIGER I7322DP Manual page 53

3.4.3 I/O Device Configuration
This setting allows you to configure I/O devices.
Main
Advanced
I/O Device Configuration
Serial port A:
Base I/O address:
Interrupt:
Serial port B:
Base I/O address:
Interrupt:
Mode:
Parallel port:
Mode:
Base I/O address:
Interrupt:
Floppy disk controller:
F1 Help Select Item
↑↓
Esc Exit Select Menu
← →
Serial Port A:
This defines how the first serial port is detected and configured.
Options: Disabled / Enabled
Base I/O Address:
Set the base I/O address for serial port A.
Options: 3F8 / 2F8 / 3E8 / 2E8
Interrupt:
Set the interrupt for serial port A.
Options: IRQ3 / IRQ4
Serial Port B:
This defines how the second serial port is detected and configured.
Options: Disabled / Enabled
Base I/O Address:
Set the base I/O address for serial port A.
Options: 3F8 / 2F8 / 3E8 / 2E8
Interrupt:
Set the interrupt for serial port A.
Options: IRQ3 / IRQ4
PhoenixBIOS Setup Utility
Security Power
[Enabled]
[3F8]
[IRQ 4]
[Enabled]
[2F8]
[IRQ 3]
[Normal]
[Enabled]
[SPP]
[378]
[IRQ 7]
[Enabled]
-/+ Change Values
Enter Select
Sub-Menu
53
http://www.tyan.com
Boot Exit
Item Specific Help
Configure serial port A
using options:
[Disabled]
No configuration
[Enabled]
User Configuration
F9 Setup Defaults
F10 Previous Values