Frequency/Voltage Control; Set Supervisor Password / Set User Password; Exit Bios Setup - TYAN TIGER 200T User Manual

3.9 Frequency/Voltage Control

This section describes the processor configuration options available. Tyan takes no responsibility and
will not be held liable for damage related to misuse of these settings.
Auto Detect DIMM/PCI CLK

3.10 Set Supervisor Password / Set User Password

Both of these functions allow for passwords to be set accordingly for BIOS configuration.
When selecting one of the password functions, the following words will appear:
After typing in a new password of up to eight characters, press [Enter]. The following words will then
appear:
Type your new password again, and the password will then be set. Please note that entering a new pass-
word and then confirming it, will clear any old password that you had (depending on type of password).

3.11 Exit BIOS Setup

You have the ability to perform the following options, either during setup or upon leaving setup.
Load Failsafe Defaults: loads the minimal settings for all devices for maximum safety
Load Optimal Defaults: loads the maximum settings for all devices
Save & Exit Setup: saves all changes, exits and reboots system
Exit Without Saving: discards all changes, exits and reboots system
* optional feature available on some Tiger 200T models
42
Auto Detect the DIMM and PCI clock settings.
[Default setting is Enabled]
ENTER PASSWORD:
CONFIRM PASSWORD:
http://www.tyan.com