TYAN TIGER 200T User Manual page 48

Creating a Security Array with an Existing Data Drive
You would use this method is you wish to use a drive that already contains data and/or is the bootable
system drive in your system. You will need another drive of identical or larger storage capacity.
FastTrak100 permits only two drives to be used for a single Mirrored array in Auto
NOTE: Setup. If a third drive is attached, it becomes a "hot" spare drive. If four drives are
attached, the Mirroring option will not be available at all.
If you are planning to use your old hard drive, backup all necessary data first. Always
NOTE: backup the data on an existing hard drive if you are planning to use it in a new sys-
tem configuration.
If you wish to include your current bootable drive using the Windows NT 4.x or Win-
dows 2000 operating system as part of the bootable Mirrored (RAID 1) array on your
FastTrak100 do NOT connect the hard drive to the FastTrak100 connector yet. You
NOTE:
MUST install the Windows NT 4.x or 2000 driver software first (from the driver disk)
while it is still attached to your existing hard drive controller. For all other operating
systems, continue using the following steps listed below.
1
Step
Choose Security under the Optimize Array for section.
2 Press <Ctrl-Y> keys to Save your selection. The window below will appear.
Step
Do you want the disk image to be duplicated to another? (Yes/No)
Y - Create and Duplicate
N - Create Only
3
Press "Y" for the Create and Duplicate option. The window below will appear asking you to
Step
select the Source drive to use. FastBuild will copy all data from the Source drive to the Target
drive.
Channel:ID
Channel:ID
Channel:ID
1 : Master
2 : Master
Use the arrow keys to choose which drive contains the existing data to be copied.
4
Step
Press <Ctrl-Y> keys to Save selection and start duplication. The following progress screen will
5
Step
appear.
Start to duplicate the image . . .
Do you want to continue? (Yes/No)
Y - Continue N - Abort
48
Source Disk
Drive Model
Target Disk
Drive Model
[Please Select a Source Disk]
Drive Model
QUANTUMCR8.4A
QUANTUMCR8.4A
[ ] Up [ ] Down [ESC] Exit [Ctrl-Y] Save
Capacity (MB)
Capacity (MB)
Capacity (MB)
8063
8063
http://www.tyan.com