Integrated Peripherals - TYAN TIGER 200T User Manual

3.5 Integrated Peripherals

This section describes settings for the integrated peripherals setup options.
On-Chip IDE Channel 0 / 1
IDE Prefetch Mode
IDE Pri/Sec Master/Slave PIO
IDE Pri/Sec Master/Slave UDMA
Init Display First
IDE HDD Block Mode
Onboard FDD Controller
Onboard Serial Port 1 / 2
UART2 Duplex Mode
IR Function*
Tx,Rx Inverting Enabled*
Onboard Parallel Port
Onboard Parallel Mode
ECP Mode Use DMA
Parallel Port EPP Type
(continued on next page)
* optional feature available on some Tiger 200T models
38
Sets the onboard support for the two IDE channels. [Default set-
ting is Enabled]
Sets support for IDE prefetching for faster drive accesses.
[Default setting is Enabled]
Sets PIO mode for each of up to four IDE devices that the
onboard IDE interface supports. [Default is Auto]
Sets whether UDMA data transfer protocol should transfer at
optimal speed, or to auto-detect optimal speed. [Default is Auto]
Sets type of display adapter installed. [Default is PCI Slot]
Sets onboard detection of optimal number of block R/W's per
sector that the drive can support. [Default is Enabled]
Sets whether onboard floppy controller should be used. [Default
is Enabled]
Sets logical COM port address and corresponding interrupt for
1st and 2nd serial ports. IR is offered on 2nd port. [Default is
Auto]
Sets whether COM port should be able to receive and transmit
data simultaneously. [Default is Half, as in Half-Duplex]
Option for IR mode setting (optional). [Default is No, Yes]
Reserved (optional). [Default is No, Yes]
Sets logical LPT port address and corresponding interrupt.
[Default setting is 378/IRQ7]
Sets mode for onboard parallel port. [Default setting is Normal]
Sets whether parallel port should use DMA for faster transfer
rate. [Default is 3]
Sets parallel port data transfer mode. [Default is EPP1.9]
http://www.tyan.com