Hammer Configuration Sub-Menu - TYAN THUNDER K8QE Manual

IDE Configuration
Floppy Configuration
I/O Device Configuration
Hardware Monitor
Auto Fan control
FanPwmDuty
Console Redirection
Watchdog Timer Option
Intruder Support
3.4.1 – Hammer Configuration Sub-Menu
You can use this screen to select options for the Hammer Configuration settings. Use
the up and down <Arrow> keys to select an item. Use the <Plus> and <Minus> keys to
change the value of the selected option.
Advanced
ECC
ECC Scrub Redirection
Dram ECC Scrub CTL
DDR Data Transfer Rate
Node Memory Inter Leave
Dram Bank Inter Leave
4GB Memory Hole Adjust
4GB Memory Hole Size
DDR Clock Jitter
Memory Hole Mapping
Enable All Memory Clocks
Controller Config Mode
Timing Config Mode
Swizzle Memory Banks
MTRR Mapping
Menu Item
Menu Item
Menu Item
Menu Item
Enabled
Disabled
30%
40%
50%
60%
Menu Item
Menu Item
Enabled
Disabled
PhoenixBIOS Setup Utility
[Enabled]
[Disabled]
[Disabled]
[200M]
[Disabled]
[Auto]
[Auto]
[64M]
[Disabled]
[Hardware]
[Populated]
[Auto]
[Auto]
[Disabled]
[Continues]
42
http://www.TYAN.com
Configure IDE interface.
Configure floppy interface.
Peripheral configuration
Enable/disable the onboard
Hardware monitor device
Choosing "Enabled" will do auto
fan control to reduce fan noise.
Select Auto fan control's PWM
duty to reduce fan speed
Additional setup menus to
configure console.
Watchdog Timer configuration
Enabled/disabled the chassis
intrude function
Item Specific Help