PCI Configuration
IDE Configuration
Floppy Configuration
I/O Device Configuration
Hardware Monitor
Auto fan control
Console Redirection
Watchdog Timer Option
3.6.1 – Hammer Configuration Sub-Menu
You can use this screen to select options for the Hammer Configuration
settings. Use the up and down <Arrow> keys to select an item. Use the <Plus>
and <Minus> keys to change the value of the selected option.
Advanced
ECC
ECC Scrub Redirection
Dram ECC Scrub CTL
MemCLK Value
Node Memory Inter leave
Dram Bank Inter leave
4GB Memory Hole Adjust
4GB Memory Hole Size
DDR Clock jitter
MemHole mapping
Enable all memory clocks
Controller config mode
Timing config mode
Swizzle memory banks
MTRR Mapping
↑↓: Select Item
F1: Help
← →: Select Screen Enter: Select
Esc: Exit
F10: Previous Values
Menu Item
Menu Item
Menu Item
Menu Item
Menu Item
Menu Item
Menu Item
Menu Item
PhoenixBIOS Setup Utility
[Enabled]
[Disabled]
[Disabled]
[200 MHz]
[Disabled]
[Auto]
[Auto]
[64MB]
[Enabled]
[Disabled]
[Populated]
[Auto]
[Auto]
[Disabled]
[Continous]
-/+: Change Values
43
http://www.tyan.com
Configure PCI devices.
Configure IDE interface.
Configure floppy interface.
Peripheral configuration
Enable/disable the onboard
Hardware monitor device
Auto fan control option
Additional setup menus to
configure console.
Watchdog Timer
configuration
Item Specific Help
F9: Setup Defaults
Sub-Menu