Table of Contents
Advertisement
Chapter 4
BIOS Configuration
Settings Chart (Continued)
Setting Option
*E P P Vers ion
P arallel P ort IR Q
*P arallel P ort DMA Channel
Onboard IDE
Onboard SCSI
Select 'Enabled' to use onboard SCSI. The settings are Enabled or Disabled.
External Onboard SCSI LED
Set this option to Enabled to direct the SCSI (onboard or add-on card) LED to
the front panel.
Power Interruption
The settings are Enabled or Disabled.
Onboard FDC
Set this option to Enabled to enable the floppy drive controller on the mother-
board. The settings are Auto, Enabled, or Disabled.
Onboard Serial Port1
This option specifies the base I/O port address of serial port 1. The settings
are Auto, Disabled, 3F8h, 2F8h, 3E8h, or 2E8h.
Onboard Serial Port2
This option specifies the base I/O port address of serial port 2. The settings
are Auto, Disabled, 3F8h, 2F8h, 3E8h, or 2E8h.
Serial Port2 Mode
This option specifies the operating mode for serial port 2. This option will not
appear if the Onboard Serial Port2 option is set to Disabled, or is set to Auto
and your system does not have an onboard serial port 2. The settings are
Normal, Sharp-IR, IrDA, and Consumer.
IR Transmission Mode
This option specifies the infrared transmission method. This option will not
appear if the Serial Port2 Mode option is set to Normal. The settings are Full or
Half.
Optim al Default Fail-Safe Default
N/A
N/A
7
7
N/A
N/A
B oth
B oth
82
http://www.tyan.com
Advertisement
Table of Contents
Troubleshooting
