TYAN THUNDER 100 Manual page 44

Chapter 3
Onboard Resource Settings
Configuration is specific to the driver you're loading for your network operat-
ing system (NOS), as shown in the following paragraphs.
To set up the duplex mode, refer to the section below that corresponds to your
operating system. Adapter performance may suffer or your adapter may not
operate if your hub does not support full duplex and you configure the adapter
to full duplex. Leave the adapter on half duplex if you are not sure what type of
hub you are connected to.
DOS ODI, NDIS 2.01 Clients
Edit the NET.CFG or PROTOCOL.INI file. Add kewords to Link Driver section:
FORCEDUPLEX 2
SPEED 100 (or 10 if 10BASE-T)
NetWare Server
In AUTOEXEC.NCF, Load E100B.LAN and add the following statement (you
must include the equal sign for servers):
FORCEDUPLEX=2
SPEED=100 (or 10 if 10BASE-T)
For more information, see the README file for NetWare servers.
Windows NT
While running Windows NT:
1. 1. From the Control Panel, double-click the Intel PROSet icon.
2.
2. PROSet examines your system and displays the Adapter Setup window. If
3.
procedure you have multiple adapters, click the "Show All Adapters" box and then select
the adapter you are configuring (you can identify it by its Ethernet address).
Each adapter must be configured separately. See "Installing Multiple Adapt-
ers" for more information.
3. From the window that appears, click Change.
4. From the Adapter Setup window, click the menu for Network Speed.
5. Click 100 or 10 Mbps, depending on hub speed.
6. Click the menu for Duplex Mode
7. Click Full.
8. Click OK when finished.
9. Click Restart Windows NT.
44
http://www.tyan.com