TYAN THUNDER 100 Manual page 20

Chapter 2
Board Installation
Place the DIMMs in an anti-static bag as soon as you remove them to avoid
static damage.
Finally, install your CPU.
Pentium II processors (233 through 450MHz) can be used on the Thunder 100.
Please refer to pages 28-30 for the correct CPU jumper settings for your board.
Remember:
The CPU is a sensitive electronic component and it can easily be damaged
·
by static electricity. Do not touch the CPU pins with your fingers.
Before the CPU is installed, the motherboard must be placed on a
·
important!
flat surface. You should be able to insert the CPU with minimal, but
firm, pressure. Do not press down hard on the CPU.
Currently, two types of cooling mechanisms are produced for Pentium II
processors: active (figure 11) and passive (figure 12). These two types of
cooling methods essentially perform the same function. The active cooler is
equipped with a cooling fan and heat sink, while the passive cooler is simply a
larger heat sink with no fan. The type of cooler used has no effect on perfor-
mance, and both types can be installed in the Pentium II slot on the Thunder
100 board.
Figure 10
20
http://www.tyan.com