TYAN THUNDER 100 Manual page 53

Stop 0x0000007B Inaccessible Boot Device
(0xFF109C50, 0x00000000, 0x00000000, 0x00000000)
2) When you are attempting to create a set of installation disks using the
WINNT /ox or WINNT32 /ox command, the following error message may be
displayed:
This floppy disk is not formatted as high-density, not formatted
with a standard Windows NT or MS-DOS format, or is corrupted.
Setup is unable to use this disk.
CAUSE OF THE PROBLEM: You are using a LS/120-type floppy disk drive.
RESOLUTION - To work around this issue, install Windows NT Worksta
tion with the /b switch. This causes Windows NT Workstation Setup to run
without requiring the installation disks.
If you are using the S1836D or are installing with Adaptec 3940 with AIC-
7895 chip then you must install NT 4.0 with a standard 1.44MB floppy disk.
Q: Where can I get Intel PRO/100 + LAN Adapter drivers?
A: You may download the drivers at http://support.intel.com/support/network/
adapter/100PDISK.HTM.
S1836 Thunder 100
53