Send The Input Signals Of Input Channels 1/2 To The Stereo Bus - Yamaha CS1D Owner's Manual

CS1D Operating Manual (Start-up)

Send the input signals of input channels 1/2 to the STEREO bus

With the operations you have performed up to this point, the signals of the STEREO bus of the PM1D system will be
output to the output jacks to which your monitor system is connected. Now we will send the signals of the input source
to the STEREO bus to verify that they can be monitored via your monitor system.
[Procedure]
1. Play back the input source. In INPUT block 1 of the
console, verify that the meter LEDs light for input
channels 1/49 and 2/50.
INPUT block 1
PAN PAN
L R L R
+48V +48V
INS A INS
B
TO ST TO ST
INPUT INPUT
GAIN GAIN
+10 -68 +10 -68
CLIP CLIP
+ +
THR THR
- -
COMP COMP
+ +
THR THR
- -
SEL GATE SEL GATE
CLIP CLIP
6 6
ON ON
12 12
18 18
30 30
60 60
50 50
60 60
CUE CUE
44
[TO ST] switch
A
B
[GAIN] encoder
[ON] switch
Meter LEDs for
input channels 1/49
and 2/50
[CUE] switch
2. If the input source is connected to a mic/line input
card (LMY2-ML), adjust the [GAIN] encoder so
that the CLIP segment of the meter LED does not
light.
3. Turn on the [ON] switches of input channels 1/49
and 2/50 (so that the LEDs are lit).
4. Turn on the [TO ST] switches of input channels 1/
49 and 2/50.
5. Raise the faders of input channels 1/49 and 2/50 to
the 0 position (nominal level).
6. In the STEREO OUTPUT block, turn on the STE-
REO [ON] switch of the ST OUTPUT A channel.
STEREO [ON]
switch of the ST
OUTPUT A
channel
Fader
STEREO OUTPUT block
ON
TO MTRX M
SEL
INS
10
5
0
5
10
20
RCL
MUTE
30
SAFE
40
50
60
CUE
ST OUTPUT ST
A