Stereo Bus - Yamaha rivage pm10 Operation Manual

Output Channels  Mixing Engine section

STEREO bus

STEREO A/B
INSERT 1
L R
PLUG-IN 1 PLUG-IN 2 PLUG-IN 3 PLUG-IN 4
INSERT 2
4
INSERT 1
DIMMER
PRE
PRE PRE
8 BAND
FILTER EQ DYNA
TALKBACK
HPF LPF
PEQ
DIMMER
TALKBACK
1 2
One can be selected within the
1 FILTER
• HPF slope
You can specify -6 dB/oct, -12 dB/oct, -18 dB/oct, or -24 dB/oct.
• LPF slope
You can specify -6 dB/oct or -12 dB/oct.
2
EQ
• 8 BAND PEQ
This is an eight-band parametric EQ. The following EQ types can be selected: PRECISE,
AGGRESSIVE, SMOOTH, or LEGACY. Two sets of EQ parameter settings (A and B) can be
saved for convenient comparison. The FREQUENCY parameter of each band is normally set
in 1/12 octave steps, but if you need more precise adjustment, you can set it in 1/24 octave
steps. The two bands LOW and HIGH can be switched to L SHELF (Low Shelving) and H
SHELF (High Shelving) respectively.
The selectable EQ types are the same as for input channels
3 DYNAMICS
One dynamics processor module is provided. You can select a dynamics function from six types,
including GATE and COMP. Two types of compressor are provided: LEGACY COMP and
COMP 260. Two sets of dynamics parameter settings (A and B) can be saved for convenient
comparison.
The selectable dynamics types are the same as for input channels
INSERT 2
PLUG-IN 1 PLUG-IN 2 PLUG-IN 3 PLUG-IN 4
LEVEL/
DCA1-24
ON
PRE POST
POST
DELAY
DELAY FADER ON
DYNAMICS
Max.1000ms
KEY IN
3 5
area
(page 18).
(page 19).
• KEY IN SOURCE
Selects the source of the key-in signal.
In addition to SELF, the key-in signal can also be selected directly from another channel or
input patch. You can use an HPF, BPF, or LPF as a KEY IN FILTER.
4 INSERT
Two inserts are provided: Insert 1 and Insert 2. In each insert, you can insert up to four plug-ins/
GEQ/PEQ/external devices (via the I/O jacks).
Each insert point can be freely specified independently.
5 DELAY
To
OUTPUT
Up to 1000 msec of delay is provided on each channel. The position at which the delay is
PATCH
BALANCE inserted is fixed at pre-fader. You can select the delay time unit from the following: meter, feet,
sample, msec, frame, depending on your application.
To
OUTPUT
PATCH
24
FAQ
CONTENTS
RIVAGE PM10 Operation Manual