Band Eq/Hpf Settings - Yamaha CS1D Owner's Manual

6. In the COMPRESSOR section of the SELECTED
OUTPUT CHANNEL block, turn on the COM-
PRESSOR [ON] switch.
The compressor of the corresponding channel will be
enabled.
7. Use the knobs and encoders of the COMPRESSOR
section to adjust parameters such as ATTACK,
RELEASE, THRESHOLD LEVEL, and GAIN.

6 band EQ/HPF settings

Here's how to use the EQUALIZER section of the SELECTED OUTPUT CHANNEL block to control the 6 band EQ.
EQ [BYPASS] switch and LED
This switch bypasses the EQ for each band.
EQ [Q] encoder and LEDs
This encoder sets the Q
(steepness) of each band. The
approximate current value is
shown by the peripheral LEDs.
EQ [ ] switch and LED
(SUB LOW band only)
This switch changes the SUB LOW
band EQ to a low shelving type.
The switch LED will light if low
shelving is selected.
In this case, the SUB LOW band
[Q] encoder will have no effect and
the peripheral LEDs will go dark.
[EQ ON] switch
This switch turns the entire
equalizer on/off.
EQ [ ] switch and LED (HIGH/SUB
LOW bands only)
This switch changes the HIGH/SUB LOW
band EQ type from peaking to shelving. If
this switch is on, the HIGH/SUB LOW
band [Q] encoders will have no effect.
Q
EQ ON
EQUALIZER
Chapter 5. Basic operation for output channels
Hint
For details on the parameters of each type, refer to
"CS1D Reference Manual (Appendices)" ( p.11).
You can make settings so that the corresponding
screen appears automatically when you operate the
COMPRESSOR section. This setting is made in the
UTILITY function PREFERENCE screen ("CS1D
Reference Manual (Software)"
EQ [LPF] switch and LED (HIGH band only)
This switch changes the HIGH band EQ type
to LPF. If this switch is on, the HIGH band [Q]/
[GAIN] encoders will have no effect.
EQ [GAIN] encoder and LEDs
This sets the gain of each band.
The adjustable range is –18 dB
– +18 dB, and the approximate
current value is shown by the
peripheral LEDs.
EQ [FREQUENCY] encoder
and [VALUE] indicator
This sets the center frequency
of each band. The range is
20 Hz – 20 kHz for each band,
and the current value is shown
by the [VALUE] indicator.
[HPF] switch and LED (SUB
LOW band only)
This switch changes the SUB
LOW band EQ type to HPF. If
this switch is on, the SUB LOW
band [Q]/[GAIN] encoders will
have no effect.
p.37).
83