Connection Of The External Buzzer - JRC JMA-2343 Instruction Manual

※ The following should be used as the plug side connector for connecting to J3 and J4
Connector
For J3
For J4

9.3.5 Connection of the external buzzer

Only qualified service personnel should perform external buzzer cabling work.
Erroneous connection may cause breakdown or defective operation.
The 5 pin connector side of the cable equipped with connector (7ZCRD0749) should be
attached to EXT2 on the rear panel of display unit after removing the rubber stopper. The
2 pin connector side should be connected to J5 of the display unit main control circuit
(CMC-1156). The 3 pin connector need not be.
Use the 5 pin connector (Type: LTWD-05BFFA-L180, JRC code: 5JCDX00015) for the plug
side connector connected to EXT2.
Main control circuit
(CMC-1156)
Type
LTWD-06BFFA-L180
LTWD-08BFFA-L180
CAUTION
External connector J5 (5 pin)
Attach after removing the rubber
stopper.
J5 (2 pin)
2 pin connector
JRC Code
5JCDX00014
5JCDX00015
Power supply circuit
(CBD-1596)
238
F1
F2