3.1.3 Adjusting monitoring and image
Display the optimal image by adjusting the [TUNE] control (in the case of manual
tuning), [GAIN] control, [SEA] control and [RAIN] control on the control panel.
The range of monitoring distance may be switched by pushing the "▲ (up)" or "▼
(down)" of on RANGE
RANGE
RANGE
RANGE
The distance range currently selected will be displayed at the lower left hand corner of
the display (please refer to "2.2 Explanation of Screen Readout").
3.1.4 Data acquisition and monitoring
Please refer to "3.3 Basic Operations" and "4 How to Interpret the PPI Screen" for the
various operations.
3.1.5 Ending the operation and shutting down the system
1. Interrupting the transmission
1. Interrupting the transmission
1. Interrupting the transmission
1. Interrupting the transmission
(a) Push the STBY/OFF
STBY/OFF key.
STBY/OFF
STBY/OFF
The transmission will be interrupted and the display will return to the standby mode.
2. Shutting the power off
2. Shutting the power off
2. Shutting the power off
2. Shutting the power off
(a) Push the X-MIT
X-MIT key and the STBY/OFF
X-MIT
X-MIT
The radar will stop operation and all functions will shut down.
When performing such work as maintenance, shut the power off and dis-
connect the power connector between the rectifier and the display to cease
supply of electricity to the system.
Even if the power switch is off, electricity may be flowing internally in the
various equipments and performing maintenance and repair under such
conditions may cause accidents such as severe electric shock or equipment
breakdown.
key.
STBY/OFF key simultaneously.
STBY/OFF
STBY/OFF
WARNING
167