Connections For Shooting Using A Flash - Sony DXC-390 Service Manual

Connections for Shooting Using a Flash

Synchronization cable
Video input
connector
Video output
connector
Note
When connecting a flash unit, set TRIGGER to ON in the
GENERAL menu (page 27) and D-SUB SYNC to WEN in
the SYSTEM menu (page 28).
56
(GB) Chapter 3 Installation and Connections
Precautions
Operating or storage location
Operating or storing the camera in the following locations
may cause damage to the camera:
• Extremely hot or cold places (Operating temperature: –5°C
to +45°C [23°F to 113°F])
• Exposed in direct sunlight for a long time, or close to
heating equipment (e.g., near heaters)
• Close to sources of strong magnetism
• Close to sources of powerful electromagnetic radiation,
such as radios or TV transmitters
• Locations subject to strong vibration or shock
Ventilation
To prevent heat buildup, do not block air circulation around
the camera.
DXC-390/390P
TRIG IN
Video monitor, VCR, etc.
Remote connector
Image processor
Video input
connector
Appendix
Flash
CMA-D2/D2MD/D2CE/
D2MDCE camera adaptor
Slave unit
DXC-390/
390P
DC IN/
VBS
VIDEO OUT
DC IN/VBS
TRIG IN
LENS
MENU LOCK
OFF ON
RGB/SYNC REMOTE
RGB/SYNC
CCDC-5/10/25/50A/100A cable
or
CCMC-12P02/05/10/25 cable
CCMC-9DSMN/CCMC-9DS/
CCXC-9DB camera cable
Transportation
When transporting the camera, repack it as originally packed
at the factory or in materials equal in quality.
Cleaning
• Use a blower to remove dust from the lens or optical filter.
• Use a soft, dry cloth to clean the external surfaces of the
camera. Stubborn stains can be removed using a soft cloth
dampened with a small quantity of detergent solution, then
wipe dry.
• Do not use volatile solvents such as alcohol, benzene or
thinners as they may damage the surface finishes.
Power cord
Set the MODE
1
selector to the "1"
2
position.
CAMERA
(4-pin or 12-pin)
4
Chapter
57
Chapter 4 Appendix (GB)
1-29 (E)