Sony DXC-390 Service Manual page 21

Adjusting and Setting with Menus
Setting item
(VBS lock)
H. PHASE*
SC. PHASE ROUGH*
SC. PHASE FINE*
(HD/VD lock)
H. PHASE*
* Displayed only when an external sync signal is input.
BAUD RATE
Switches the baud rate of the REMOTE
rear panel.
Sets to any of 19200, 9600, 4800, 2400 and 1200.
Normally, set to 9600 when the RM-C950 remote control
unit is connected to the REMOTE
D-SUB VIDEO
Switches the video signal output from the
connector (D-sub 9-pin) at the rear panel.
Selection Function
Outputs VBS signal.
VBS
Outputs Y/C signal.
Y/C
28
(GB) Chapter 2 Operation
12P CONNECTOR
Switches the input and output of the
connector (12-pin). Selects the output signal from this
connector when OUT is selected.
Selection Function
Functions as the input connector.
IN
Functions as the output connector.
OUT
Select the output signal with the SIGNAL setting.
HD/VD: Outputs the HD/VD signal.
C. SYNC: Outputs the composite sync signal.
VBS lock
Appears only when an external reference sync signal (VBS
signal) is input. Adjusts the horizontal phase and SC
(subcarrier) phase to synchronize the camera operation with
the reference signal.
Selection Function
H.PHASE Adjusts the horizontal phase within the range from
–20 to +127.
SC.PHASE Roughly adjusts the subcarrier phase by setting to 0°
ROUGH or 180°.
SC.PHASE Finely adjusts the subcarrier phase within the range
FINE from –127 to +127.
DXC-390/390P
Contents of setting Ref. page
Adjusts the horizontal phase and 29
SC (subcarrier) phase during
external synchronization (with
VBS signal input).
Adjusts the horizontal phase 30
during external synchronization
(with HD/VD signal input).
connector at the
connector.
RGB/SYNC
DC IN/VBS
D-SUB SYNC
Switches the sync signal output from the
connector (D-sub 9-pin) at the rear panel.
Selection Function
Outputs the composite sync signal.
C.SYNC
Outputs the WEN signal. When connecting peripheral
WEN
equipment, the signal is used as trigger pulse output to
the equipment.
Select the polarity of the WEN signal with the
POLARITY setting.
: Negative
: Positive
RGB SYNC
Adds a sync signal to the G signal or R, G and B signals
output from the RGB/SYNC connector.
Selection Function
No sync signal is added to an output signal.
OFF
Adds a sync signal to the G signal output from the
G
RGB/SYNC connector.
Adds sync signals added to the G, B and R signals
RGB
output from the RGB/SYNC connector.
HD/VD lock
Appears only when an external reference sync signal (HD/
VD signal) is input. Adjusts the horizontal phase to
synchronize the camera operation with the reference signal.
Select H.PHASE, then adjust the level within the range from
–20 to +127.
RGB/SYNC
29
Chapter 2 Operation (GB)
1-15 (E)