Management Networks Configuration; User Access Control Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual

Table 91 System Access Configuration commands
Command
access tftp-port <TFTP port
number>
show access

Management Networks configuration

The following table describes the Management Networks Configuration commands. You can configure up to 10
management networks on the GbE2c.
Table 92 Management Networks Configuration commands
Command
access management-network <IP
address> <IP mask>
no access management-network <IP
address> <IP mask>
show access management-network

User Access Control configuration

The following table describes the User Access Control commands.
Table 93 User Access Control Configuration commands
Command
access user <1-10>
access user eject <1-10>
access user user-password
<1-128 characters>
access user operator-
password <1-128
characters>
access user
administrator-password
<1-128 characters>
show access user
Description
Sets an optional telnet server port number for cases where the server listens for
TFTP sessions on a non-standard port.
Command mode: Global configuration
Displays the current system access parameters.
Command mode: All
Description
Adds a defined network through which switch access is allowed through
Telnet, SNMP, RIP, or the browser-based interface. A range of IP
addresses is produced when used with a network mask address. Specify
an IP address and mask address in dotted-decimal notation.
Command mode: Global configuration
Removes a defined network, which consists of a management network
address and a management network mask address.
Command mode: Global configuration
Displays the current management networks parameters.
Command mode: All except User EXEC
Description
Configures the User ID.
Command mode: Global configuration
Ejects the selected user from the switch.
Command mode: Global configuration
Sets the user ( ) password (maximum of 128 characters). The user has no direct
user
responsibility for switch management. He or she can view switch status information
and statistics, but cannot make any configuration changes.
Command mode: Global configuration
Sets the operator ( ) password (maximum of 128 characters). The operator
oper
manages all functions of the switch. He or she can view all switch information and
statistics and can reset ports or the entire switch.
Command mode: Global configuration
Sets the administrator ( ) password (maximum of 128 characters). The super
admin
user administrator has complete access to all information and configuration
commands on the switch, including the ability to change both the user and
administrator passwords.
Command mode: Global configuration
Displays the current user status.
Command mode: All
Configuration Commands 94