Spanning Tree Port Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual

The following table describes the Bridge Spanning Tree Configuration commands.
Table 108 Bridge Spanning Tree Configuration commands
Command
spanning-tree stp {<1-128>}
bridge priority {<0-65535>}
spanning-tree stp {<1-128>}
bridge hello-time {<1-10>}
spanning-tree stp {<1-128>}
bridge maximum-age {<6-40>}
spanning-tree stp {<1-128>}
bridge forward-delay {<4-30>}
show spanning-tree stp {<1-128>}
bridge
When configuring STP bridge parameters, the following formulas must be used:
2*(fwd-1) > mxage
2*(hello+1) < mxage

Spanning Tree port configuration

By default for STP/PVST+, Spanning tree is turned Off for downlink ports (1-16), and turned On for cross-connect
ports (17-18), and uplink ports (20-24). By default for RSTP/MSTP, Spanning tree is turned On for all downlink ports
(1-16), all cross-connect ports (17-18), and all uplink ports (20-24), with downlink ports configured as Edge ports.
Spanning tree port parameters are used to modify STP operation on an individual port basis. STP port parameters
include:
Port priority
Port path cost
Description
Configures the bridge priority. The bridge priority parameter controls which
bridge on the network is the STP root bridge.
To make this switch the root bridge, configure the bridge priority lower than
all other switches and bridges on your network. The lower the value, the
higher the bridge priority. The range is 0 to 65535, and the default is
32768.
RSTP/MSTP: The range is 0 to 61440, in steps of 4096 (0, 4096, 8192...),
and the default is 32768.
This command does not apply to MSTP. See the "Common Internal Spanning
Tree configuration" section for more information.
Command mode: Global configuration
Configures the bridge hello time. The hello time specifies how often the
root bridge transmits a configuration bridge protocol data unit (BPDU).
Any bridge that is not the root bridge uses the root bridge hello value.
The range is 1 to 10 seconds, and the default is 2 seconds.
This command does not apply to MSTP. See the "Common Internal
Spanning Tree configuration" section for more information.
Command mode: Global configuration
Configures the bridge maximum age. The maximum age parameter
specifies the maximum time the bridge waits without receiving a
configuration bridge protocol data unit before it reconfigures the STP
network. The range is 6 to 40 seconds, and the default is 20 seconds.
This command does not apply to MSTP. See the "Common Internal
Spanning Tree configuration" section for more information.
Command mode: Global configuration
Configures the bridge forward delay parameter. The forward delay
parameter specifies the amount of time that a bridge port has to wait
before it changes from the listening state to the learning state and from
the learning state to the forwarding state. The range is 4 to 30 seconds,
and the default is 15 seconds.
This command does not apply to MSTP. See the "Common Internal
Spanning Tree configuration" section for more information.
Command mode: Global configuration
Displays the current bridge STP parameters.
Command mode: All
Configuration Commands 105