HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual page 116

The following table describes the RIP Interface Configuration commands.
Table 128 RIP Interface Configuration commands
Command
ip rip version {1|2|both}
[no] ip rip supply
[no] ip rip listen
[no] ip rip poison
[no] ip rip split-horizon
[no] ip rip triggered
[no] ip rip multicast-
updates
[no] ip rip default-action
{both|listen|supply}
[no] ip rip metric {<1-15>}
[no] ip rip authentication
type {<password>}
ip rip authentication key
{<password>}
ip rip enable
no ip rip enable
show interface ip [<1-256>]
rip
Description
Configures the RIP version used by this interface.
The default value is version .
2
Command mode: Interface IP
When enabled, the switch supplies routes to other routers. This command is
enabled by default.
Command mode: Interface IP
When enabled, the switch learns routes from other routers. This command is
enabled by default.
Command mode: Interface IP
When enabled, the switch uses split horizon with poisoned reverse. When
disabled, the switch uses only split horizon. This command is disabled by
default.
Command mode: Interface IP
Enables or disables split horizon. The default value is
Enables or disables Triggered Updates. Triggered Updates are used to speed
convergence. When enabled, Triggered Updates force a router to send update
messages immediately, even if it is not yet time for the update message. The
default value is .
disabled
Command mode: Interface IP
Enables or disables multicast updates of the routing table (using address
224.0.0.9). The default value is
Command mode: Interface IP
When enabled, the switch accepts RIP default routes from other routers, but
gives them lower priority than configured default gateways. When disabled,
the switch rejects RIP default routes. This command is disabled by default.
Command mode: Interface IP
Configures the route metric, which indicates the relative distance to the
destination. The default value is
Command mode: Interface IP
Configures the authentication type. The default is
Command mode: Interface IP
Configures the authentication key password.
Command mode: Interface IP
Enables this RIP interface.
Command mode: Interface IP
Disables this RIP interface.
Command mode: Interface IP
Displays the current RIP configuration.
Command mode: All except User EXEC
enabled
.
enabled
.
1
.
none
Configuration Commands 116
.