Resetting The Switch; Accessing The Aos Cli - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual

Resetting the switch

You can reset the switch to make your software image file and configuration block changes occur.
Resetting the switch causes the Spanning Tree Protocol to restart. This process can be lengthy, depending on the
topology of your network.
To reset the switch, at the prompt, enter:
>> Switch# reload
You are prompted to confirm your request.
To display current boot options, enter:
>> Switch# show boot

Accessing the AOS CLI

To access the AOS CLI, enter the following command from the ISCLI, and reload the switch:
>> Switch# boot cli-mode aos
The default command-line interface for the GbE2c is the AOS CLI. To access the ISCLI, enter the following command
and reset the GbE2c:
Main# boot/mode iscli
Users can select the CLI mode upon login, if the following command is enabled:
boot cli-mode prompt
Only an administrator connected through the console port can view and enable the prompt command. When
prompt is enabled, the first user to log in can select the CLI mode. Subsequent users must use the selected CLI mode,
until all users have logged out.
Boot Options 146