Basic Operation; Checking The Xm Signal Strength And Radio; Presetting Radio Stations (Preset Memory) - Denon AVR-2309CI Owner's Manual

ENGLISH
Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
unit
Button only on the main unit
Button only on the remote control unit
<SOURCE SELECT> SHIFT
<STATUS> TUNING
[Front]
SHIFT
TUNING
[CHANNEL +/–]
uiop
[SOURCE
CONTROL 1]
[Rear]
TUNING
[MEMORY]


Basic Operation

1
Either turn
BUTTON
to select "XM".
<BUTTON>
2
[BUTTON] [SOURCE CONTROL 1]
Set
CONTROL 2]
(vpage 65 "Remote Control Unit Operations")
PRESET
ui
3
TUNING
Use
When the station is tuned in, the name of the track and artist
are displayed.
• The channel switches continuously when
held.
• The artist name, track name, category and reception level can be
checked by pressing
• The time for which the on-screen display are displayed can be set
op
at menu "Manual Setup" – "Option Setup" – "On-Screen Display"
(vpage 36).
[SAT TU1/2]
Checking the XM Signal Strength and
Radio ID
1
Either turn
to select "XM".
2
Press
display.
The display will switch as shown below, depending on the
reception conditions.
Display
[SOURCE
GOOD
CONTROL 2]
MARGINAL
WEAK
NO
[SAT TU 1/2]
3
Adjust the position of the antenna until "SIGNAL:
GOOD" is shown on the display.
4
Press
uiop
(example: "XM001") is displayed.
<SOURCE SELECT> [SAT TU 1/2]
or press
to "AUDIO" and
to "TUNER".
to select the station.
TUNING
is pressed and
<STATUS>
.
<SOURCE SELECT> [SAT TU 1/2]
or press
<STATUS>
until "SIGNAL" appears on the
Status
Signal strength is good
Signal strength is marginal
Signal strength is weak
No signal
<STATUS>
until the station you want to check
5
TUNING
Press and select channel 0 (XM000).
The radio ID is shown on the display.
[SOURCE
The strength of both the XM satellite and terrestrial signals can be
checked at menu "Input Setup" – "Antenna Aiming" (vpage 43).
Presetting Radio Stations
(Preset Memory)
Your favorite broadcast stations can be preset so that you can
tune them in easily. Up to 56 stations can be preset.
1
Tune in the broadcast station you want to preset.
2
[MEMORY]
Press .
3
SHIFT
Press to select the block (A to G) in which the
station is to be preset.
4
<PRESET> CHANNEL + –
Press or
number (1 to 8).
5
[MEMORY]
Press again to complete the setting.
To preset other stations, repeat steps 1 to 5.
NOTE
Preset stations are erased by overwriting them.
Radio ID
to select the preset