Preparations - Denon AVR-2309CI Owner's Manual

ENGLISH
Auto Setup
Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
unit
Button only on the main unit
Button only on the remote control unit
MASTER VOLUME ui
RETURN
<SPEAKERS>
[Front]
[Rear]
uio

• Audyssey MultEQ
in the listening environment to create the best audio experience for
your home theater.
• Audyssey MultEQ optimizes a large listening area where one or
BUTTON
more listeners are seated.
<BUTTON>
Measurements are performed by placing the calibrated microphone
[BUTTON]
(DM-A409) successively at multiple positions throughout the
listening area as shown in Example q. For best results, it is strongly
recommended to measure 6 positions so that the measurements
have the proper spatial weighting.
Even if the listening environment is small as shown in Example w,
measuring at multiple points throughout the listening environment
results in more effective correction.
Example q
( :Measuring positions)
ENTER,o
*
MASTER VOLUME
About the main listening position (*M)
The main listening position refers to the most central position where
one would normally sit within the listening environment.
MultEQ uses the measurements from this position to calculate
speaker distance, level, polarity, and the optimum crossover value
for the subwoofer.
ENTER
RETURN
To make manual adjustments to the settings, see pages 29 ~ 31.
®
automatically measures the acoustical problems
Example w
*
M M

Preparations

1
Connect the included calibrated setup microphone to
SETUP MIC
the jack on the main unit.
The auto setup screen appears automatically.
Sound
receptor
2
Place the microphone at ear height on a tripod or stand
with the microphone pointing directly up towards the
ceiling.
Setup
microphone
b Do not hold the microphone in your hand during measurements.
Be sure that the path from microphone to the speakers is not
blocked by objects. Avoid placing the microphone close to a seat
back or wall as sound reflections may give inaccurate results.
When using a subwoofer, make the following settings before starting
the auto setup procedure:
• Defeat the volume and crossover controls if possible
• If this is not possible then set
Volume: "12 o'clock" position
•
Crossover frequency: "Maximum/Highest Frequency"
•
Low pass filter: "Off"
•
Standby mode: "Off"
•