Denon AVR-2309CI Owner's Manual page 30

ENGLISH
Step 2 : Measurement
F Menu screen F
q
Auto Setup
Audyssey MultEQ
Step2:Measurement
Please place microphone
Step2:Measurement
at ear height at
Now measuring 2nd
2nd listening position.
listening position.
Next
Calculate
Cancel
e
Auto Setup
Audyssey MultEQ
Step2:Measurement
Please place microphone
at ear height at
3nd listening position.
Next
Calculate
Retry
Cancel
u to select "Next 0", then press
q Press
• The measurement of the 2nd position starts.
w Move the microphone to the 3rd position and press
• The measurement of the 3rd position starts.
e Perform w repeatedly for the 4th, 5th, and 6th measurments.
• "All the measurements were finished. " is displayed on the on-
screen display. When you have completed measurements in 6
positions.
• If you want to stop after measuring just five or fewer positions,
press to select "Cancel 0", then press
i
After completing a measurement position, move the microphone to
the next position.
Measure at 6 positions: the main listening position and 5 other
surrounding positions. Although it is allowable to measure less than 6
positions, it is recommended to measure 6 for best results.

Step 3 : Calculation
F Menu screen F
w
Auto Setup
Auto Setup
Step2:Measurement
Audyssey MultEQ
All the measurements
were finished.
Calculate
Retry
Front L
Cancel
Cancel
The values obtained from the measurements are automatically
analyzed and the attributes for each of the speakers in the listening
area are determined.
u to select "Calculate 0", then press
q Press
• Analysis begins.
• Analysis takes several minutes to complete.
• The time required for this analysis depends on the number of
o .
speakers connected. The greater the number of speakers connected,
the longer analysis will take.
.
o
NOTE
• Do not change the speaker connections or subwoofer volume,
or speaker locations after making measurements. If changes are
necessary, make the changes and use the Audyssey MultEQ auto
setup once again for an updated EQ solution.
• For instance, if the location or direction of a speaker is altered, the
.
o
Auto Setup should be performed again to ensure the correct EQ
solution for the new room configuration.
q
Audyssey MultEQ
Auto Setup
Audyssey MultEQ
Step3:Calculation
Calculating
Please wait...
– – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – –
o .
Step 4 : Check
F Menu screen F
q
Auto Setup
Audyssey MultEQ
Step4:Check
Please check the results
of the measured item.
Speaker Config.Check
Distance Check
Channel Level Check
Crossover Freq.Check
Next
When analysis is complete, check the analysis results for the following
four items.
q Make your selection using u i and press
• Presence and size of speaker
"Speaker Config. Check"
• Distance of speaker from listening position
"Distance Check"
• Speaker channel level
"Channel Level Check"
• Crossover Frequency
"Crossover Freq. Check"
ui to change which speaker is displayed.
w Use
n To switch to another analysis result item
RETURN
Press .
This returns you to analysis results items, so repeat step q.
n To proceed to "Step 5 : Store"
Press u to select "Next 0", then press o
Distance values that are greater than the actual distance of a speaker
may be accurate for speakers with built-in filters (subwoofers, etc).
This is because these filters add electrical delay (distance) to the signal
that is compensated for by the Auto Setup process.
ENTER
.
.