Installing The Image Transfer Belt Cleaning Unit - Ricoh Pro C900 Replacement Manual

7.2 INSTALLING THE IMAGE TRANSFER BELT
CLEANING UNIT
Procedure
1. While holding the image transfer belt cleaning unit with both hands, set the
image transfer belt cleaning unit (1) on its rails (2), and then carefully push it in
until it can go no further.
2. Fasten the black screw (1) on the image transfer belt cleaning unit using the
hex driver.
3. Reconnect the ground leakage circuit breaker for the machine and fixing heater.
4. Press the main power switch to turn the machine on, close the left and right
front cover, and then wait for the machine to warm up.
5. Open the TCRU display. (See "OPENING THE TCRU DISPLAY".)
6. Press the [Image Transfer Belt Cleaning Unit] button.
7. Press the [Reset PM Counter:Image Transfer Belt Cleaning Unit] button.
8. If a confirmation message appears, press the [Continue] button.
Note: The counter will be reset.
9. When the counter is reset, press the [Confirm] button.
10. Open the left and right front covers.
2
1
RPG040
44
2
1
RPG041