Advanced > Management > Snmp > Snmpv3 - Kyocera FS C5015N - Color LED Printer Operation Manual

COMMAND CENTER Pages
Advanced > Management > SNMP > SNMPv3
3-45
Enter the community name for SNMP requests to read a value. The default
name is 'public'. After you have changed the setting, you must restart the
printing system.
Write Community
Enter the community name for SNMP requests to write (change) a value.
The default name is 'public'. After you have changed the setting, you must
restart the printing system.
sysContact
The MIB-II sysContact object. Usually this is the E-mail address of the
network administrator.
sysName
The MIB-II sysName object. Usually this is the host or domain name of the
printing system.
sysLocation
The MIB-II sysLocation object. Usually this is the location information of the
printing system.
HP Web Jetadmin Compatibility
Turns HP Web Jetadmin Compatibility On or Off. After you have changed
the setting, you must restart the printing system.
Authentication Traps
Specifies whether to use authentication traps. If enabled (On), an SNMP trap
is generated when an attempt to read or write is made using an incorrect
community name. The trap is sent to the configured trap address. After you
have changed the setting, you must restart the printing system.
Trap Community
The SNMP trap community name to be used when the printing system
generates a trap.
Trap IP Address (IPv4)
Enter the IPv4 address that receives traps. Select On to enable trap
receiving.
Trap IP Address (IPv6)
Enter the IPv6 address that receives traps. Select On to enable trap
receiving.
Trap IPX Address
Enter the IPX address that receives traps. Select On to enable trap
receiving.
Selected Errors
Select the events which will cause a trap to be generated from Add Paper,
Low Toner, Add Toner, Cover Open, Paper Jam, and All Other Errors.
The section below provides a summary of the items displayed on the SNMPv3
page. After you have changed the setting, you must restart the printing system.
For details, refer to .
SNMPv3
Sets whether to use the SNMPv3 protocol. Set On to use it.
Authentication
User Guide