Driveline Lubrication - Alamo none Operator's Manual

DRIVELINE LUBRICATION

Grease Fittings are located on the Cross Assembly of each U-Joint and on the telescoping tubes. Grease the
U-Joint after each 8 hours of use. Image Mnt-FL-0061. Do not force grease through the Needle Cup
Assemblies. Grease the telescoping tubes after every 8 hours use. Some PTO-to-Hitch connections may
necessitate cutting a hole in the shields to be able to align the Grease Fitting holes for lubrication. Lubricate the
shield bearings every 16 hours. Image Mnt-FL-0062.
The Driveline Integral Shields should not become dented or otherwise damaged. The Integral Shield
Assembly has a Nylon Bearing at each end and should turn freely. This nylon bearing should require
lubrication every 8 hours. To remove the Integral Shields for replacement or repair, turn the three Nylon Nuts 1/
4 turn in the Shield Slots of the Cone and Tube and remove them. Slip the Shield Cone Assembly off inner
section of the Driveline. Install the new or repaired Shield on the Driveline. Place the split Nylon Bearing over
the Driveline Housing of Shaft against the Yoke and in the Bearing groove. Install shield over the Housing so
the Nylon Bearing fits into the Shield Bearing Retainer. Align a slot in the Shield Cone with one of the slots in
the Shield. Put one of the Nylon Nuts back in through the aligned slots and turn until it is perpendicular to the
slots. Add the other two Nylon Nuts.
Make certain that the Driveline Integral Shields are free to telescope and rotate around the
Driveline without binding.
GRASS KING 03/09
© 2009 Alamo Group Inc.
MAINTENANCE
U-Joint Lubrication
Driveline Maintenance
Maintenance Section 5-4