Pre-Operation Inspection And Service - Alamo none Operator's Manual

Alamo industrial flail mower operator's manual

Table of Contents

5. If the engaged length is less than 8", the shaft is considered too short and should be replaced with a longer

shaft. Consult an authorized dealer to purchase the required driveline length.

NOTE: If the driveline cannot be shortened and still maintain the required profile engagement, the

operator must be made aware of terrain conditions and avoid situations which pose a potential problem to

avoid damaging the driveline.

9. PRE-OPERATION INSPECTION AND SERVICE

Before each use, a pre-operation inspection and service of the mower and tractor must be performed. This

includes routine maintenance and scheduled lubrication, inspecting that all safety devices are equipped and

functional, and performing needed repairs. Do not operate the mower and tractor if the pre-operation

inspection reveals any condition affecting safe operation. Perform repairs and replacement of damaged and

missing parts as soon as noticed. By performing a thorough pre-operation inspection and service, valuable

down time and repair cost can be avoided.

Always disconnect the main PTO Driveline from the Tractor before performing service on

the Implement. Never work on the Implement with the tractor PTO driveline connected and

running. Rotating Parts, Blades or Drivelines could turn without warning and cause immedi-

ate entanglement, injury or death.

DO NOT allow any person under a folded wing unless wing is securely

locked up or supported. DO NOT approach the Implement unless the

Tractor is turned off and all motion has ceased. Never work under the

frame work, or any lifted component unless the implement is securely

supported or blocked up. A sudden or inadvertent fall by any of these

components could cause serious injury or even death.

Periodically inspect all moving parts for wear and replace when

necessary with authorized service parts. Look for loose fasteners, worn

or broken parts, and leaky or loose fittings. Make sure all pins have

cotter pins and washers. Serious injury may occur from not maintaining

this machine in good working order.

GRASS KING 03/09

OPERATION

(S3PT-11)

(SG-21)

Operation Section 4-16

(STI-03)

Table of Contents