Fc Splitter; Crossover - Lexicon MPX 1 - REV 2 User Manual

MPX 1 User Guide

Fc Splitter

The Fc Splitter effect splits a
mono input into a low-passed out-
put on the left channel and a high-
passed output on the right, with
independent control of the corner
frequencies of both filters. If the
corner frequencies are the same,
and the balance is set to 0, the
frequency response will be flat
when the two outputs are summed.
Bal controls the relative level of left
and right outputs. When Bal=0, the
left and right outputs are not at-
tenuated. Negative values attenu-
ate the right output (highs). Posi-
tive values attenuate the left (lows).
OpenTheDoor

Crossover

The Crossover effect is similar
to Fc Splitter, but with only one
crossover frequency, shared by
low and high. In this effect, Level
and Bal are not interpolated.
Fazer Tremolo OD Rotary
7-16
Mix 0-100%
Level* Off, -89 to +6dB
LoCut 100-10000Hz
HiCut 100-10000Hz
Bal* -50 to +50
Mix 0-100%
Level Off, -89 to +6dB
Fc 100-10000Hz
Bal -50 to +50
* = Interpolated; ( ) = Option of preceding parameter
Dry/Wet ratio
Amount of effect in the processed signal
Corner frequency for the low cut (highpass)band
Corner frequency for the high cut (lowpass) band
Relative level of the low and high band
Dry/Wet ratio
Amount of effect in the processed signal
Crossover frequency
Relative level of the low and high band
Lexicon