Quick Start For Hardware - Intel PCLA4251B - Netportexpress Pro Enet EXT 10BT Single Port Setup Manual

Quick Start
for Hardware
1
Install NetportExpress 10 or 10/100
Print Server
1 Connect the network cable to the RJ-45 or BNC connector. If you are
using an RJ-45 jack, use Category 5 cable.
2 Connect the printer cable to the printer and the print server.
3 Plug the power cable into the print server.
Single-port
R E
S E
T
P A
R A
3
2
1
After connecting the power cable, wait one minute. When the activity light is
solid green, the NetportExpress print server is ready to be configured. Press the
Test Page button to send a test page from the print server to any connected
printer. The test page includes the print server's Device ID, IP address, and other
configuration information. If you cannot print a test page, see Can't print a test
page on page 26.
L L
E L
L A
S W N
1
R J
- 4 5
1 0
0
1
NetportExpress 10
3-port
1
3
2
2
NetportExpress 10/100