Using Netport Manager; Using Web Netport Manager - Intel PCLA4251B - Netportexpress Pro Enet EXT 10BT Single Port Setup Manual

Using Netport Manager

View status
Select a NetportExpress print server and then click the Status button.
Change the configuration
Right-click a print server and then click Configure Print Services.
Change port settings for your printer
Select a print server. Click the Configure button, click Device Properties, and
click a Port tab.
Set an IP address
Right-click the print server, and click TCP/IP and SNMP.
Reset a NetportExpress print server to factory defaults
Right-click the NetportExpress print server and click Factory Defaults.
Update a print server
Select the print server and click the Update button. To select multiple print
servers, press and hold down the CTRL key.
Change a password
Select the print server. Click the Options menu and click Passwords. If you
forget your password, see passwords in the Online Guide index.

Using Web Netport Manager

To access Web Netport Manager, your browser must be set up to browse your
network, and the NetportExpress print server must have an IP address.
Browse to a NetportExpress print server
G To find out if the print server has an IP address, print a test or diag page by
pressing the Test Page or Diag button on the print server. If the print server
has an IP address, the IP address is listed on the test page.
G To assign an IP address, see Set an IP address in the previous section.
G To browse to a print server, open your Web browser, type the
NetportExpress print server IP address in the Internet address box, and
press Enter.
18