Can't Print With Microsoft Printing; Can't Print With Novell - Intel PCLA4251B - Netportexpress Pro Enet EXT 10BT Single Port Setup Manual

G Make sure your printer can be networked, see Can my printer be
networked? on page 7. For a list of tested printers, see
http://support.intel.com/support/netport/printers.htm.
G Make sure that a printer password has not been set or changed on the print
server. See passwords in the Online Guide index. If a printer password has
been set, you must to reconfigure the computer to print using that password.
See the instructions in this guide for configuring Windows or UNIX
systems to print. Printer passwords do not affect Novell print server, Novell
remote printer, or AppleTalk printing.
Can't access the print server
G Try using a different management utility, such as Netport Manager or Web
Netport Manager.
G Reset the print server to factory defaults (NetportExpress 10/100 and 10
print servers only). This resets all configuration information on the print
server. Unplug the print server and then hold down the Test Page button
while plugging in the print server. After about 20 seconds, the Activity light
will rapidly flash amber. Release the Test Page button. Press the Test Page
button again.

Can't print with Microsoft printing

G Make sure you haven't disabled protocols on the print server. Microsoft
Printing must be enabled. To check in Netport Manager or Web Netport
Manager, click Options and then click Protocol Enable/Disable.
G If you have set a printer password on the print server, run the
NetportExpress Add Printer Wizard and set up the computer to print using
the password.

Can't print with Novell

Make sure you haven't disabled protocols on the print server. Novell Printing
must be enabled. To check in Netport Manager or Web Netport Manager, click
Options, and then click Protocol Enable/Disable. For Novell printing over TCP/
IP, make sure TCP/IP printing is enabled.
24