The Event List; Using Time Code To Initiate Program Changes - Lexicon 300 - V3.0 REV Owner's Manual

The 300 allows you to use time code (in any of the recognized formats) to trigger
Setup, Effect, and parameter changes.
Up to 50 time code entries can be made on an Event List. Time codes can be
entered via the numeric keypad, they can be "snapped" on the fly while time code
is running, or they can be selected with the soft knob.
To access the Event List simply press the front panel CONTROL button to enter
Control mode, then use the Page Down button to step to the Event List display:
Event List:
ADD
Pressing the second button from the right on the top row allows you to choose
to have a Timecode Event list enabled (ON) or disabled (OFF).
Pressing any of the bottom row of buttons selects a page of controls for the item
displayed directly above that button. Four pages are available for: addition of
events to the list (ADD), deletion of items from the list (DEL), modification of
entries (EDIT), and "on the fly" insertion of items to the list (SNAP).
The 300 automatically sorts the Event List based on the time code addresses.
If you add a new event it will be placed on the list at the appropriate place, and
other entries will move in position. If you delete an entry, the remaining entries
will retain their relative positions, but will move up one position.
Pressing this button
enables/disables the Event List
OFF
DEL EDIT
Pressing one of these buttons se-
lects a control page for the Event
List

The Event List

Using time code to
initiate program
changes
VIEW
SNAP
Time Code Operation
6-3