Cascade Setups - Lexicon 300 - V3.0 REV Owner's Manual

When working in a fixed format (with only analog or digital Dual Mono inputs),
each machine has its own level control. The output of each level adjustment is
split to each source balance control. Each Dual Mono Setup Preset defaults to
ABAL panned to LEFT ONLY, and BBAL panned to RIGHT ONLY. (AIN, ABAL,
BIN, and BBAL are located on Page Two of the Setup Edit mode.)
*If you had, for example, a piano in the left input and a voice in the right input and
both Balances were set to 50%, a summed input with equal amounts of piano and
voice would be passed to each DSP engine.
A dry signal is picked off before the signal passes into each Split DSP Effect. The
mono wet output of each DSP effect sums with the dry signal and is proportion-
ally mixed under the MIX controls: AMIX and BMIX. The third SETUP EDIT page
contains AMIX and BMIX.) Continuing with the above example, if both AMIX and
BMIX were set to 0%WET (or 100% DRY), you could use AIN and BIN as level
controls, mixing two independent signals to mono as part of an analog or digital
process.
Cascade Setups are another type of "Split" configuration. They are numbered
301-325 in Setup Select mode. While in Setup Select mode, you can use the Soft
knob to locate the Cascade Setups. Pressing ENTER will load two split type
programs: one in Machine A, the other in Machine B.
Analog or
Digital
L
Input Input
Level Balance
R
Dry
Patch Points
EFFECT
EDIT A
Patch Points
Dry
Feedback
A
EFFECT
Mix
EDIT B
Feedback
System Operation

Cascade Setups

Out
B Overall
Mix Mix
Out
L
R
3-7