Effect Edit Mode; Parameter Selection - Lexicon 300 - V3.0 REV Owner's Manual

300 V 3.0 Owner's Manual

Effect Edit Mode

Parameter Selection

SETUP CONTROL
SELECT
MACH SETUP
EDIT
STORE EFFECT
EDIT
VALUE MOD
EDIT
3-18
The 300 is shipped with 100 effect presets. Sooner or later you will want to alter
the sounds of these effects to more perfectly fit your requirements. To do this,go
to Run mode and load a preset setup that uses the effect you want to edit — or
select and load the effect you want to edit from Page One in Setup Edit mode.
Once the setup is loaded, pressing EFFECT EDIT will put you in Effect Edit
mode with the display showing one page of the parameters available for the
algorithm driving that effect.
The algorithms and their parameters are described in detail in Chapter 4. We've
chosen the first page of Random Hall parameters to show here as an example:
RTIM
RLVL
The buttons directly above and below each display entry will select that
parameter. Once selected, parameters can be adjusted over their entire range
with the Soft knob. The parameter and its current value will appear on the display
as long as the Sof tknob is being adjusted. In the example above, "RTIM" has
been selected — turning the Soft knob will alter the parameter value, and cause
the display to show:
Mid Reverb Time
XX.XX seconds
Pressing the front panel VALUE key will display all of the current parameter
values for the selected page. in this example, pressing VALUE will cause the
following display to appear:
XX.Xs
FULL
SIZE ROLL
TDCY BASS
37.1M 2.9k
3.6k 1.2X
Lexicon
PDLY
XOVR
22m
0.5k