Lexicon 300 - V3.0 REV Owner's Manual page 96

300 V 3.0 Owner's Manual
Single Setup
Presets cont'd.
# Name
P126 * Rich Plate
P127 Glossy Plate
P128 Warm Plate
P129 Perc Plate
P130 Contem-Plate
P131 *EKO Plate
P132 Bright Plate
P133 * Round Plate
# Name
P134 StereoAdjust
P135 Phase Invert
P136 2 Frame Delay
P137 3 Frame Delay
P138 4 Frame Delay
P139 MS Decode
P140 *MultiEchoes
P141 LFO Panner
P142 Telephone
5-4
Algorithm
Rich Plate The old standard comes back to the future. Advancing the Soft knob
controls the reverb time negatively.
Rich Plate This preset shines a little differently. Some close in pre-echoes gives
a strong impact to the original source.
Rich Plate Not your average bright plate — rather a slightly dull version which will
work very well on horn tracks, adding point and definition.
Rich Plate For drums and the like. Not bad on piano either.
Rich Plate Bright and splashy-sounding. Should work well to brighten a track
without getting too washy-sounding.
Rich Plate Combines a sweet combination of recirculating pre-echoes and bright
sounding reverb. The Soft knob is negatively patched to RTIM and
Delays 1 and 2.
Rich Plate Slightly smaller version of Contem-Plate. Great of vocals. Some
strong pre-echoes to help the direct sound stand out.
Rich Plate Soft, but articulate. The Soft knob is patched to feedback paths
surrounding pre-echoes 1 and 2, which feedback into the
reverberator.
Algorithm
Stereo Adjust Sets you up to fix audio sources. Null preset with pages for EQ,
delays, phase and channel swaps, and DC offset removal.
Stereo Adjust The right channel is phase reversed to the left. If you put a mono
signal into this program and pan the output returns left and right,
you'll definitely twist your head off.
*NOTE This phase-reversed mono signal will also decode to the
surround channel if run through a surround decoder.
Stereo Adjust 66.3 ms of delay running at 44.1kHz and 65.9 ms at 48kHz.
Stereo Adjust 100 ms of delay at both operating frequencies.
Stereo Adjust 133 ms of delay at both operating frequencies.
Stereo Adjust Take a 2-channel Mid (left input) Side (right input) recording and this
program will properly decode to stereo output.
Stereo Adjust This preset combines echoes under the control of the Soft knob. As
you advance the Soft knob, the delays will get longer.
Stereo Adjust This preset attaches the LFO to the Stereo Adjust balance control.
Once again, the LFO Rate determines the speed of the pan. This
preset should be used from a pre-fade send source.
Stereo Adjust No bottom end....AT ALL.
Description
Description
Lexicon