Time Code: Snap And View; Time Code: Event List And Time Code Edit/Add/Delete - Lexicon M300L Owner's Manual

300L Owner's Manual
Page Seven
Time Code:
Snap and View
Page Eight
Time Code: Event List
and Time Code
Edit/Add/Delete
3-32
This page provides the top level of control for Time Code Automation.
OFF
OFF
This slider selects Time Code modes: OFF (Time Code reception disabled),
VIEW (view the running event list), and SNAP (enter an event into the list). When
SNAP is selected, the button below the SNAP slider is active and will "snap"
entries into the list. (This occurs if time code is running or not).
CLR (Clear)
Pressing the button below the CLR slider will clear the last snapped event from
the list.
This page allows editing of the event list.
EDIT TC
EDIT
Slider 1 lets you select any event to EDIT, ADD, or DELete from the event list.
Your selection is shown on the upper display.
TC (Time Code Offset)
Slider 2 allows you to adjust a plus or minus 4 second offset to the currently
displayed edit event (1-50). Pressing the button below the the TC slider drops
you into a sub page which allows you to enter a time code via the numeric keypad
or to assign Hours: Minutes: Seconds: and Frames via the associated sliders.
+ – H:
EXIT
Press the button under the EXIT slider to return to the Event Edit page.
TYPE
This slider selects between Setups and Effects for either Machine A or Machine
B, and parameter glides for MA:, MB:, or Setups.
SEL
The SEL slider allows you to select the actual Setup or Effect.
To return to the main Edit Page, press the button under the EDIT slider. For
additional information on Time Code, see Chapter 6.
TYPE SEL
M: S:
Lexicon
F: EXIT