Programmable Band-Scan Limit - Yaesu FT-7100M Operating Manual

P
This feature allows you to set sub-band limits for either scanning or manual VFO operation.
For example, you might wish to set up a limit (in North America) of 144.300 MHz to 148.00
MHz so as to prevent encroachment into the SSB/CW "Weak Signal" portion of the band
below 144.300 MHz. Here's how to do this:
1. Set the radio to the VFO mode by pressing the [ V/M ] key, if necessary.
2. Using the techniques learned earlier, store (per above example) 144.300 MHz into Memory
Channel "L1" (the "L" designates the Lower sub-band limit).
3. Likewise, store 148.000 MHz into Memory Channel "U1 " (the "U" designates the Upper
sub-band limit).
4. Switch to the Memory Recall mode by pressing the [ V/M ] key once, then recall Memory
Channel "L1" or "U 1 ."
5. Press the [ MHz ] key momentarily; the "
6. You may now rotate the Main Dial knob, or begin scanning by press and holding in the
microphone's [ UP ] / [ DWN ] button for 1/2 second. The transceiver will behave as though
it is in the standard VFO mode, but operation will be restricted to the range between
Memory channels "L1" and "U 1 ."
Five pairs of Band Limit memories, labeled "L1/U 1 " through "L5/U 5 ," are available. You
therefore can set a number of operating sub-bands, if you like.
FT-7100M Operating Manual
ROGRAMMABLE
S
CANNING
B -S
AND CAN
" icon will appear on the display. .
F
EATURES
L
IMITS
37