Memory Operation; Memory Storage; Storing Independent Transmit Frequencies ("Odd Splits") - Yaesu FT-7100M Operating Manual

1. Select the desired frequency, while operating in the VFO mode. Be sure to set up any
CTCSS or DCS tones as well as any desired repeater offset. The power level may also be
set at this time, if you wish to store it at a particular level of interest.
2. Press and hold in the [ V/M ] key for 1/2 second.
3. Within the three seconds of releasing the [ V/M ] key, use
the Main Dial knob (or the microphone's [ UP ] / [ DWN ]
buttons) to select the desired memory channel. The memory
channel number will blinking on the LCD.
4. To attach an alpha/numeric name (label) to the memory, press the [ V/M ] key momen-
tarily; otherwise press and hold in the [ V/M ] key for 1/2 second to save the entry and
exit.
5. To label a memory with an alpha/numeric name, use the Main Dial knob (or the
microphone's [ UP ] / [ DWN ] buttons) to select any of the 80 available characters (includ-
ing letters, numbers, and special symbols). When the desired first character appears,
press the [ LOW ] key momentarily to move on to the next character.
6. Select succeeding characters in the same manner, pressing the [ LOW ] key momentarily
after each selection.
7. You may move to the back character by pressing the [ BAND ] key momentarily. Press and
hold the [ BAND ] key for 1/2 second to erase the charactors at the right.
8. After entering the entire name (five characters maximum for upper display filed, six for
lower field), press and hold in the [ V/M ] key for 1/2 second to save all data for the channel
and exit.

Storing Independent Transmit Frequencies ("Odd Splits")

All memories can store an independent transmit frequency, for operation on repeaters with
non-standard shifts. Both frequencies must be inside the same amateur band. To do this:
1. Store the receiving frequency (and label the channel with an alpha/numeric name, if
desired) using the method already described under "Memory Storage" (it does not
matter if a repeater offset is active).
2. Tune to the desired transmit frequency, then press and hold in the [ V/M ] key for 1/2
second.
3. Within the three seconds of releasing the [ V/M ] key, rotate the Main Dial knob (or press
the microphone's [ UP ] / [ DWN ] buttons) to select the same memory channel number as
used in step 1 above.
4. Press and hold in the PTT switch; while holding it in, press and hold in the [ V/M ] key for
1/2 second once more (this does not key the transmitter).
FT-7100M Operating Manual
M
EMORY
M S
EMORY TORAGE
O
PERATION
Memory Channel Number
31