Frequency Display And Band Change; Main Dial Tuning; Direct Keypad Frequency Entry (Requires Mh-48 A6J ) - Yaesu FT-7100M Operating Manual

Frequency Display and Band Change

If the transceiver has not been used before, the display will
look something like this:
We call the upper frequency the "main" band, and the lower
frequency the "sub" band. Transmission is possible only on
the "main" band, but you can select both bands to receive
different frequencies on the same band (V-V or U-U opera-
tion, described later).
To change the "main" band between VHF and UHF, simply
press the [ BAND ] key momentarily (default: "main" band is
VHF, "sub" band is UHF).

Main Dial Tuning

This mode is used for choosing a frequency within the "main" band.
In the "VFO" mode, the Main Dial knob and microphone [ UP ] / [ DWN ] buttons allow the
Variable Frequency Oscillator (VFO) to tune in the selected step size. When scanning in the
VFO mode, the same step sizes are used as in manual tuning.
To select the 1 MHz range in which you wish to operate, press the [ MHz ] key momentarily,
then rotate the Main Dial knob. All the "MHz" digits of the frequency display will blink
while "1 MHz Tuning" is enabled. Press the [ MHz ] key again (momentarily), then rotate the
Main Dial knob to tune around the "main" band in the normal synthesizer step.
To select the 10 MHz range in which you wish to operate (if you are making a major frequency
change, for example), press and hold in the [ MHz ] key for 1/2 second, then rotate the Main
Dial knob. The 10 MHz and 100 MHz digits of the frequency display will blink while "10 MHz
Tuning" is enabled. Press and hold in the [ MHz ] key again (for more than 1/2 second), then
rotate the Main Dial knob to tune around the "main" band in the normal synthesizer step.
Direct Keypad Frequency Entry (Requires MH-48
The desired operating frequency may be entered directly from the microphone's keypad.
To enter a frequency from the keypad, just press the numbered digits on the keypad in the
proper sequence. To round all digits to the right of the current digit to "0," press the [ # ] key.
Example:
To enter 146.520 MHz, press [ 1 ] à [ 4 ] à [ 6 ] à [ 5 ] à [ 2 ] à [ 0 ] .
To enter 433.000 MHz, press [ 4 ] à [ 3 ] à [ 3 ] à [ # ] .
FT-7100M Operating Manual
B O
ASIC PERATION
O
/R
ECEPTION
European Version
)
A6J
PERATION
USA Version
19