External Speaker Selection - Yaesu FT-7100M Operating Manual

You can select the audio output configuration for the speakers when an external speaker is
connected to the EXT SP jack on the rear panel.
To select the speaker to be used on a particular band:
1. Press and hold in the [ BAND ] key for 1/2 second to activate the "Menu" mode.
2. Rotate the Main Dial knob to select Menu #28 (SPCNT).
3. Press the [ BAND ] key momentarily to enable changing of this Menu item.
4. Rotate the Main Dial knob to select the new setting. The options include:
BAND A : Directs VHF band audio to the external speaker, and UHF band audio to the
internal speaker. During V-V operation (VHF) audio from the upper frequency
display field on the LCD is sent to the external speaker, while (VHF) audio
from the lower frequency display field on the LCD is sent to the internal
speaker. Conversely, during U-U operation, upper-display-field UHF audio
is sent to the internal speaker, and lower-display-field UHF audio is sent to
the external speaker.
BAND B : Directs UHF band audio to the external speaker, and VHF band audio to the
internal speaker. During V-V operation (VHF) audio from the upper frequency
display field on the LCD is sent to the internal speaker, while (VHF) audio
from the lower frequency display field on the LCD is sent to the external
speaker. Conversely, during U-U operation, upper-display-field UHF audio
is sent to the external speaker, and lower-display-field UHF audio is sent to
the internal speaker.
BOTH:
Outputs both VHF and UHF band audio from the external speaker, and turns
off the internal speaker.
OFF:
Turns off the external speaker, and outputs both VHF and UHF band audio
from the internal speaker.
5. Press and hold in the [ BAND ] key for 1/2 second to save the new configuration and exit
to normal operation.
Some or all transceiver settings can be reset to their factory-default states using one of the
following power-on routines:
FT-7100M Operating Manual
M
ISCELLANEOUS
E S
XTERNAL
S
PEAKER ELECTION
S
ETTINGS
45