Programming The Microphone Button Functions - Yaesu FT-7100M Operating Manual

P
ROGRAMMING THE
Default FT-7100M button functions have been assigned (at the factory) to the microphone's
buttons*. These may be changed by the user, if you wish to define another function for a
particular button or buttons
To change the assignment of a button's function:
1. Press and hold in the [ BAND ] key for 1/2 second to activate the "Menu" mode.
2. Rotate the Main Dial knob to select the
Menu item corresponding to the button
to be assigned a function (20: P G P 1,
21: PG P2 , 22: PG P3 , or 23: PG P4).
3. Press the [ BAND ] key momentarily to enable changing of the selected Menu item.
4. Rotate the Main Dial knob to select the function you wish to assign to the button you
selected in the previous step. The available choices are:
SQL OFF : Disables (opens) the Noise and Tone Squelch.
TCALL:
Activates 1750 Hz Tone Burst.
RPTR:
Selects Repeater Shift Direction.
PRI:
Activates Priority Channel monitoring.
LOW:
Selects Power Output Level.
TONE:
Selects CTCSS or DCS mode and tone/code.
MHz:
Enables selection of the "MHz" digit of the frequency.
REV:
Reverses Repeater Uplink/Downlink frequencies.
HOME:
Switches frequency to the "Home" channel.
BAND :
Selects "main" band of operation: VHF or UHF.
VFO /MR: Switches frequency control between VFO and Memory.
5. Press and hold in the [ BAND ] key for 1/2 second to save the new setting(s) and exit to
normal operation.
: [ P1 ] , [ P2 ] , [ P3 ] , and [ P4 ] buttons.
*: MH-48
A6J
: [ ACC ] , [ P ] , [ P1 ] , and [ P2 ] buttons.
MH-42
B6JS
FT-7100M Operating Manual
M
ISCELLANEOUS
M
ICROPHONE
M
20: P G P 1
21: P G P 2
22: P G P 3
23: P G P 4
B
UTTON
I MH-48 L
ENU TEM A6J
[ P1 ] button
[ P2 ] button
[ P3 ] button
[ P4 ] button
S
ETTINGS
F
UNCTIONS
MH-42 L
ABEL B6JS ABEL
[ ACC ] button
[ P ] button
[ P1 ] button
[ P2 ] button
43