Antenna Selection - Yaesu FT DX 9000 CONTEST - MANUAL 2 Operation Manual

Four main antenna jacks, available for both transmission and reception, are provided on the rear panel of the transceiver.
What's more, a receive-only jack is provided, and the incoming signal path may also have a special after-market filter or
preamplifier inserted, if desired, with one-touch access.
Selection of the desired TX/RX antenna is accomplished
by pressing the appropriate 1 ~ 4 Antenna Selection
switch (# ) on the front panel.
To engage the RX-only antenna, press the RX switch
within the Antenna Selection switch group (#
front panel. The RX-only antenna must be connected to
the corresponding "RX ANT" antenna jack on the rear
panel.
The antenna currently selected for use on the VFO-A will
be designated by a Red LED.
The antenna currently selected for use on the VFO-B will
be designated by an Orange LED.
If both VFOs are utilizing the same antenna, both the Red
and Orange LEDs will light up on the same antenna loca-
tion.
ANT "1"
ANT "2"
ANT "3"
ANT "4"
RX OUT
BPF
RX ANT
RX OUT
FT 9000 C
DX ONTEST
A
NTENNA
) on the
ANTENNA SWITCH
( VFO-A )
( A )
( B )
ANTENNA SWITCH
( VFO-B )
O M
PERATION ANUAL
C
ONVENIENT
S
ELECTION
ANTENNA SELECT switch
TX/RX RELAY
RX ANTENNA SWITCH
( VFO-A )
RX ANTENNA SWITCH
( VFO-B )
F
EATURES
Transmitter
Section
VFO-A/-B SWITCH
Receiver
Section
Page 49