Yaesu FT DX 9000 CONTEST - MANUAL 2 Operation Manual page 119

DISPLAY G
017. ROTATOR START UP
Function: Selects the starting point of your controller's
indicator needle.
Available Values: 0/90/180/270º
Default Setting: 0º
018. ROTATOR OFFSET ADJ
Function: Adjusts the indicator needle precisely to
the starting point set in menu selection 123.
Available Values: –30 - 0
Default Setting: 0
019. RIGHT TX METER
Function: Selects the Sub meter function
Available Values: ALC/VDD
Default Setting: ALC
ALC: Indicates incoming signal strength on the sub
band (VFO-B) while receiving, and indicates the
ALC (Automatic Level Control) operating range
while transmitting.
VDD: Indicates the Vdd (final amplifier drain voltage)
at all times.
020. QMB MARKER
Function: Enables/Disable the QMB Maker (White
arrow " ") to display on the Spectrum Band Scope.
Available Values: ENABLE/DISABLE
Default Setting: ENABLE
Advice: If the optional Data Management Unit (DMU-
9000) is not installed, this selection has no effect un-
less you are using an external display in conjunction
with the DMU-9000.
FT 9000 C
DX ONTEST
ROUP
O M
PERATION ANUAL
M
FH-2 SETUP G
021. BEACON TIME
Function: Sets the interval time between repeats of
the beacon message.
Available Values: OFF/1 ~ 255 sec
Default Setting: OFF
022. CONTEST NUMBER
Function: Selects the Contest Number "Cut" format
for imbedded contest number.
Available Values: 1290/AUNO/AUNT/A2NO/A2NT/
12NO/12NT
Default Setting: 1290
1290: Does not abbreviate the Contest Number
AUNO: Abbreviates to "A" for "One," "U" for "Two,"
"N" for "Nine," and "O" for "Zero."
AUNT: Abbreviates to "A" for "One," "U" for "Two,"
"N" for "Nine," and "T" for "Zero."
A2NO: Abbreviates to "A" for "One," "N" for "Nine,"
and "O" for "Zero."
A2NT: Abbreviates to "A" for "One," "N" for "Nine,"
and "T" for "Zero."
12NO: Abbreviates to "N" for "Nine" and "O" for
"Zero."
12NT: Abbreviates to "N" for "Nine" and "T" for
"Zero."
023. CW MEMORY 1
Function: Permits entry of the CW message for mes-
sage register 1.
Available Values: TEXT/MESSAGE
Default Setting: MESSAGE
TEXT: You may enter the CW message from a
supplied FH-2 Remote Control Keypad.
MESSAGE: You may enter the CW message from
the CW keyer.
024. CW MEMORY 2
Function: Permits entry of the CW message for mes-
sage register 2.
Available Values: TEXT/MESSAGE
Default Setting: MESSAGE
TEXT: You may enter the CW message from a
supplied FH-2 Remote Control Keypad.
MESSAGE: You may enter the CW message from
the CW keyer.
025. CW MEMORY 3
Function: Permits entry of the CW message for mes-
sage register 3.
Available Values: TEXT/MESSAGE
Default Setting: MESSAGE
TEXT: You may enter the CW message from a
supplied FH-2 Remote Control Keypad.
MESSAGE: You may enter the CW message from
the CW keyer.
M
ENU ODE
ROUP
Page 117